o

Network type   AVG S Tool searches for AVG Anti Virus on network stations either in the 

range of a domain from which the installation is launched (i.e. where the station with AVG S 

Tool installed is located), or within the range defined by the IP addresses (on the previous 

AVG Agent tab). 

o

Scan network   After pressing this button, AVG S Tool will start inspecting separate network 

workstations for the AVG Agent service and AVG Anti Virus presence. The search results are 

then displayed using the following icons: 

Station found (the station is registered in the domain); the station status has not been 

inspected yet 

Neither AVG Agent nor AVG Anti Virus are installed on the workstation 

AVG Agent is installed on the workstation; AVG Anti Virus is not installed 

Both AVG Agent and AVG Anti Virus are installed on the workstation 

An error occurred while communicating with the station. Double click to show detailed 

information. Typically, an error occurs if communication with AVG Agent is blocked (e.g. 

by a firewall), or your password is invalid 

While searching the network, AVG S Tool shows a dialog providing information on progress of 

the required operation. Press the Cancel button to stop the operation at any time. 

o

Workstations   The option displays the current number of stations on which the desired 

operations should be performed. 

o

Force install   The option specifies that the AVG Agent service together with AVG Anti Virus 

should be installed even on stations where AVG Anti Virus is already installed. This 

functionality allows you to perform AVG Anti Virus reinstallation on all network workstations. 

o

Mask password   Selecting this option will prevent the password from being displayed on 

your computer's monitor. 

o

AVG Agent password   Enter the password that will protect communication between AVG S 

Tool and the AVG Agent service on remote workstations. If the password is specified, no 

operations using the AVG S Tool can be performed on the remote workstations without 

knowing it. The password is related to the AVG Agent service only, and it does not influence 

any other remote station settings. This password must be specified BEFORE you launch AVG 

Agent installation on remote workstations! 

To change the AVG Agent password, follow these steps: 

Type the new password into the AVG Agent password field 

Select the Force install option! 

Run AVG Anti Virus remote installation 

A dialog asking for the AVG Agent password will be displayed   enter the original 

password into this dialog! 

After the installation, the AVG Agent on the station uses the new password already 

Copyright (c) 1992 2005 GRISOFT, s.r.o. All rights reserved. 

35