On the Network tab you will find the following options: 

o

Network type   AVG S Tool searches for AVG Anti Virus on network stations either in the 

range of a domain from which the installation is launched (i.e. where the station with AVG S 

Tool installed is located), or within the range defined by the IP addresses. 

o

Workstations   The option displays the current number of stations on which the desired 

operations should be performed. 

o

Force install   The option specifies that the AVG Agent service together with AVG Anti Virus 

should be installed even on stations where AVG Anti Virus is already installed. This function 

allows you to perform AVG Anti Virus reinstallation on all network workstations. 

o

From IP, to IP   If you selected the option of searching the network in the range defined by 

IP addresses, you need to specify the range by entering the IP addresses here. 

Note: 

When launched for the first time, AVG S Tool will try to fill in the IP addresses according the 

network configuration set on the station where the AVG S Tool application is running. 

However, if you know the exact IP address range of network stations, adjust the values 

manually to shorten the time needed for searching the network. 

o

Mask password   Selecting this option will prevent the password from being displayed on 

your computer's monitor. 

o

AVG Agent password   Enter the password that will protect communication between AVG S 

Tool and the AVG Agent service on remote workstations. Then no operations using the AVG S 

Tool can be performed on the remote workstations without knowing the password. The 

password is related to the AVG Agent service only, and it does not influence any other remote 

Copyright (c) 1992 2005 GRISOFT, s.r.o. All rights reserved. 

23