Chapter 8      Command Reference

Privilege Level 15 Commands

Usage guidelines

To set the configuration for all backup and restore operations, use the backup 

command. 

Example

The following command will configure the backup and restore operations to 

backup to and restore from host 10.11.12.13, set the username to user1, and set 

the password to pass:

backupconfig 209.165.200.224 user1 pass

The following command clears all backup and restore configuration information:

no backupconfig

Related Commands

backup, page 8 11

listbackup, page 8 29

restore, page 8 41

show backupconfig, page 8 45

cdp

Use the cdp command to configure the Cisco Discovery Protocol:

cdp {run | timer seconds | holdtime seconds}

no cdp {run | timer | holdtime}

Syntax Description

run

start cdp

timer

set cdp packets retransmission time.

holdtime

set cdp packet info hold time.

port

Ethernet port on which CDP will be enabled. Acceptable 

values are eth0 15.

seconds

amount of time, in seconds, that the system takes to either 

transmit the cdp packet information or to hold another 

system's cdp packet information.

User Guide for the CiscoWorks Hosting Solution Engine 1.8.1

OL 6319 01

8 13